Click on an image to read or save a pdf of the case study.

Single Buoy Moorings

Water-jetting for surface prep, with Alocit coating on wet surfaces immediately after saves money.

Containment Enclosures

Porous walls could require reconstruction - but using Alocit on to oil-soaked walls is no problem.

Sweating Pipes

Cold pipes in a warm humid atmosphere under Malaysia’s famous Petronas Twin Towers.

Steel Refurbishment

Old Victorian infrastructure rusting in a moist atmosphere, constantly at dewpoint.

Below: splash zone application of Alocit to the legs of a gas platform

Floors

Alocit is ideal as a primer on problem substrates as well as a very hard wearing.top coat

Rail Bridge in Winter

Steel beams on a rail bridge needed coating - but it was too wet and cold for other coatings

Bilge Areas

Application on the USS Detroit “performing flawlessly”. NAVSEA commissioned report.

Waste Water

First applied in the Sixties - thirty years later the original coating is still in excellent condition.

Offshore

Alocit application in the splash zone on a gas platform in an environmentally sensitive area.

Tunnels

An application in a damp and dirty Swiss rail tunnel uses Alocit to coat over oily concrete.

Pile Coating

From New York Harbour to Taiwan, Alocit has proved its durability and ease of use.

Green and wet concrete

Normally, a high moisture content in concrete can cause delays - but not if you use Alocit.

Tried & Tested

Alocit is being successfully applied in more than 30 countries around the world with major distributors in Asia, Australia, Europe and the Americas

All material copyright © A&E Group 2009-2014. Alocit is manufactured and distributed by A&E Group who are also responsible for the content of this website - see ‘Legal Info’ for further details. For comments and suggestions about this website please email comms@ae-sys.com